| Work areas |
|---|
| Max. height |
205 mm |
| Max. width |
1000 mm |
| Swing diameter above machine bed |
410 mm |
| Swing diameter in bed bridge |
540 mm |
| Turning length in bed bridge |
165 mm |
| Bed width |
206 mm |
- Hardened and ground Z-axis guideway
- Spindle mount Camlock DIN ISO 702-2 No. 5
- Precisely crafted sled
- Handwheels with adjustable fine scale 0.04 / 0.02 mm
- Quadruple tool holder
- All guides can be adjusted by wedge strips
- Adjustment range upper slide ± 90 °
- Guaranteed concentricity of the spindle nose better than 0.015 mm
- Main spindle running in oil bath
- Gear wheels smooth, hardened and ground
- Gears and shafts hardened and ground, running in an oil bath in precision bearings
- Handwheels decoupled and tested according to EN 23125
- Two-channel right-left switch tested to EN 23125
- Switch with life cycle calculation, tested according to EN ISO 13849
- DC 24 Volt - electrics
- Lockable main switch
- Right / left rotation on bed sled switchable
- Safety handwheels with release function in the X and Z axis
- Tailstock for taper turning ± 10 mm adjustable
- Tailstock quill and hand wheel with adjustable fine scale 0.025 mm
- Fast, easy and tool-free adjustment by means of a clamping lever
- Strongly ribbed prism bed, induction hardened and precision ground from gray cast iron
- Extractable chip tray with guide rails
- Emergency stop device with foot control
- Machine base with 3 panels (no compartments)
- Coolant system
- LED machine lamp in chip protection
- Fixed bezel passage Ø 5 - 85 mm
- Running bezel passage Ø 5 - 65 mm
- LED machine light
- Reduction sleeve MK 6 / MK 3
- Fixed centering points MK 3
- Fixed centering point MK 3, alloyed
- Revolving centering point MK 3
- Position stop with fine adjustment
- Change gear set
- Initial machine filling with quality oil
- operating tool
- Quadruple steel holder 16 mm
Do not forget the lathe chuck!
